VIThe safe use of Round Slings
Store and handle roundslings correctly.
- Inspect roundslings and accessories before use and before placing into storage.
- Follow safe slinging practices, as given overleaf.
- Position the bight for choke lift at 120°(natural angle).
- Apply correct mode factor for the slinging arrangement.
- Use protection (to avoid cutting, friction etc) and fittings which allow the sling to form smooth radii.
Roundslings are available in a range of materials and sizes in endless sling form. Select the slings to be used and plan the lift taking the following into account: Material – polyester is resistant to moderate strength acids but is damaged by alkalis; polyamide (Nylon) is virtually immune to alkalis but is damaged by acids; polypropylene is little affected by acids or alkalis but is damaged by some
solvents, tars and paints. Capacity – the sling must be both long enough and strong enough for the load and the slinging method. Apply the mode factor for the slinging method. For use at temperatures exceeding 80°C or below 0°C refer to the suppliers instructions. – If the slings are to be used in multi-leg arrangement the angle formed between the legs should not be less than 30° or greater than 90°.
– If abrasion, heat generated by friction or cutting from edges or corners which may damage the sling are likely, select a sling fitted with additional protective sleeves and/or use suitable packing. Storing and Handling Roundslings Never return wet, damaged or contaminated slings to storage. They should be cleaned with clear water and dried naturally.
